Home / Fence Guides

Fence Guide · 5 min read

Setting Posts That Stay Put in Montgomery County Ground

Sand on top, slow-draining clay and ironstone below. What that means for depth, concrete, and gate posts when we build a new fence.

By the 76 Fence of Magnolia team · Updated

Most of the ground we dig around Magnolia, Pinehurst, and Montgomery looks easy for the first couple of feet. The auger runs through tan sand quickly, and then things change: the hole gets tighter, the color turns mottled red and gray, and on some lots the bottom starts filling with water before we're done. How a post is set in that kind of ground decides whether the fence stays straight.

This page covers how we set posts on a new fence. If you already have a post that's leaning, our guide to fixing a leaning post in sandy soil is the better read.

What's under a typical Magnolia-area yard

The most common soil in Montgomery County, according to the NRCS soil survey, is Conroe loamy fine sand, which covers about 11 percent of the county. The runners-up are Fetzer loamy fine sand and two fine sandy loams, Splendora and Woodville. The USDA describes the Conroe series as loamy fine sand on top with sandy clay loam and clay underneath that carries plinthite (the reddish, iron-rich layer most people call ironstone), and it drains slowly.

That's a different problem from the heavy clay closer to Houston. Conroe-series clay is kaolinitic, a kind that doesn't swell and shrink much, though some parts of the county do have heavier clays. On most lots we work, the issue isn't ground heaving. It's that sand doesn't grip a post well, and the layer under it holds water.

Three things we watch for in the hole

Sand that won't hold its shape

Dry sand caves in from the sides as you dig, so a hole can end up wide at the top and narrow at the bottom. That cone shape puts the least concrete where the post needs the most support. In deep sand we dig deeper and wider so the footing has more to bear against.

Ironstone and clay at depth

The plinthite layer is hard enough to stop an auger. Quitting there leaves a post shallower than it should be, so we work through it to reach full depth rather than settling for wherever the digging got hard.

Water standing in the hole

Because the subsoil drains slowly, rain can perch on top of the clay, and a fresh hole on a low lot may partly fill within minutes. Pour concrete into that and the water thins the mix, leaving a soft footing. The water comes out before the concrete goes in, and on a soaked day it's better to reschedule a section than to set posts in mud.

Our baseline, and when we go past it

Concrete goes around every post we set. On a wood fence, each post gets a hole at least 24 inches deep and 80 pounds of concrete, and we treat that as the floor, not the goal. Loose sand, wet ground, and taller fences all call for more.

PostWhat it carriesHow we set it
Line postIts share of the panels and wind24" minimum with 80 lb of concrete; go deeper or wider in loose or soggy sand
Corner and end postWind plus pull from two directions; wire tension on chain linkDeeper, larger footing than line posts
Gate postThe whole gate hanging from one side, plus every slamThe deepest, widest footings on the job, sized to the gate
Posts behind solid panels or slatsExtra wind loadDepth and spacing sized for the wind the fence will see

Gates and corners get their own spec

A gate post works like a lever. A wide gate hanging from one post pulls sideways at the top all day, and every slam jolts the footing. In sand, that's where a lean shows up first, so gate posts get the most depth and concrete we put in the ground. Drive gates get posts sized to the gate's weight and width. Corner and end posts come next, especially on chain link, where they hold the tension of the whole run.

Wire fences on acreage work differently. Long runs of field wire or no-climb rely on braced corner assemblies, such as H-braces, to hold tension, not on concrete alone. See acreage and ranch fencing for how we lay those out. Our short page on why fence posts fail lists what goes wrong when any of this is skipped.

Lake lots, creek bottoms, and fill

Lots on the west side of Lake Conroe and along the Spring Creek and Lake Creek bottoms bring wetter ground, and holes there can hit saturated sand quickly. On lakefront lots we also confirm where the property line sits relative to the SJRA's 201-foot contour before posts go in near the water. Newer lots built up with fill get a closer look too, since fill is often looser than the native ground beside it.

Protecting the post at the ground line

The ground line is where wood posts rot. We put a rot board on every wood fence unless you ask us not to, which keeps the pickets off the soil, and we recommend keeping mulch and soil pulled back from the posts. If you want a wood fence whose posts outlast the boards, ask us about galvanized steel posts behind the wood, since steel won't rot or feed termites at grade. Vinyl and ornamental metal posts still need the same depth and concrete; the soil doesn't care what the fence is made of.

Curious what's under your yard? The USDA's Web Soil Survey maps soil types by location, or we can tell you what we find when we dig. Book a free estimate and we'll explain how we'd set posts on your lot, or call (281) 292-1897.

Quick answers

Is Montgomery County soil the same as Houston gumbo?

No. Most of the county is sandy loam over a slower-draining clay subsoil, not the heavy black clay common closer to Houston. Some areas do have heavier clays, so the soil on your lot is worth checking.

Should posts be set in gravel instead of concrete?

We set every post in concrete. In our loose sandy topsoil, gravel alone gives a post little to bear against, especially at gates and corners.

Will my soil change the price of the fence?

It can. Extra depth, wider footings, and more concrete at gates and corners add material and labor. Our pricing guide explains what’s built into a typical quote.

Keep reading

FAQ

Why do fence posts fail around Magnolia?

Most failed posts trace back to how they were set in our sandy ground, not to the fence material. Here are the usual causes.

Read more →
Fence Guide

How to Fix a Leaning Fence Post in Sandy Soil

A leaning post tells you what went wrong underground. Here's how to read it, and when a brace is enough versus a full reset.

Read more →
Page

Fence Pricing Guide — Magnolia, TX

Read more →

Ready for a free estimate?

Call or text us, or book a time for us to walk your property and give you a written quote.